Carbide Material
It has increased the profile of the tooth and allows quickly remove material. Rotary burrs with a head, which is an enlarged tooth is good to work with non-reinforced steel and alloys. It gives the best performance. Boron Carbide with diamond head Grinding is designed to handle hardened materials. Rotary burrs are also used in this work with a variety of high-strength alloys. It has excellent stability.
After processing a surface of Rotary burrs material is particularly smooth and clean. Chips obtained in the processing of this powder. Rotary burrs with advanced head enchant is useful when working with such seasoned materials, which are important in the treatment of maximum purity workpiece. Chips in the treatment produces long. Boron Carbide with dual-head enchant – this is a very effective Rotary burrs. Easily and accurately takes the material surface which after processing is clean and smooth.
Gives small chips during processing. Rotary burrs from head configuration of the "chip breaker," enables you to handle without sticking material, producing a maximum snyatie.Chtoby Rotary burrs last longer on quality Rotary burrs are usually applied to a special multi-layer coating. It increases endurance Rotary burrs, extends tool life by 50-70%. Especially when such coverage is necessary working with glass or stainless steel, metal and other hard materials. The life of the Rotary burrs help correct her appeal. When working with any boron carbide must abide by a few simple rules. Firstly, in no case be too much pressure on the Rotary burrs. From this its speed drops, the instrument overheating. The result is premature wear of the working part Rotary burrs. In addition, you should always ensure maximum contact with the working part of the Rotary burrs material being treated. As a result of his treatment will be easier. Should not be allowed to touch the workpiece Shank Rotary burrs. Tool to be otherwise, can overheat and solder – weaken or collapse. Rotary burrs if not new, but rather worn when handling materials operator inadvertently presses heavily on the tool. From this Last overheated and damaged. In the worst case this can cause damage to most vehicles Straight. It is therefore better time to replace the Rotary burrs with a large percentage of wear on the new one. You can also use re-sharpened tool. To head Rotary burrs on the surface skolzila better the material will not cause congestion, we must work with a special lubricant to use. During treatment should be regularly lowered into the working part of her instrument. Usually used as a lubricant liquid wax or synthetic grease. In addition, it is important to remember that the correct parameters handling of materials – guarantee Rotary burrs durability. It is very important when processing surfaces to observe high speed tool. This avoids an unnecessary roughness and burrs on the product that best handle the corners and grooves. In addition, desired speed is a guarantee of sticking with carbide bur. Due to the fact that Rotary burrs jams, breaks its core. Rotary burrs different peripheral speed in the range of 450-950 meters per minute. Therefore it is better if Straight machine is able to work with Rotary burrs of different sizes and speeds.